When information, such as the remaining
amount of media, is printed, a line is printed at
the cut position. Print Information is printed on
the printed side of the cut position, and Paper
Remaining Information is printed on the unused
side, so cut along that line.
c
Important:
When you cut the media, check that it does not
rise up inside the front cover or has not come
free from the media edge plate before printing.
D
Take up the cut media completely by operating
the Manual switch according to how the media is
rolled.
Removing Media
Caution:
❏ If the media weighs over 20 kg, it should not be
carried by one person. When loading or
removing the media, use at least two people.
❏ Follow the instructions in the manual when
loading media or roll cores or removing the
take-up roll.
Dropping media, roll cores, or take-up rolls
could result in injury.
A
Rotate the left media holder handle to the far side
until it stops.
The part A on the illustration and the shaft of the
handle will be visible.
B
To prevent the media from sliding off the roll,
support the roll at its left end.
C
Loosen the left media holder fixing screw and
remove the media holder.
D
Lower the roll onto the roll support.
Be careful not to trap your hands between the roll
and the roll support.
E
To prevent the media from sliding off the roll,
support the roll at its right end.
SC-F10000 Series User's Guide
Basic Operations
86
To Next Page
Loading...
Need help?
General