N
Insert the media approximately 20 cm into the
opening, then lower the media loading lever.
The media that you inserted is clamped and does
not fall out.
O
Confirm that the left edge of the media is within
the range of the label's rectangle in the
illustration below.
c
Important:
If the left edge of the media is not within the
black square of the label, do Steps 6 to 15 in
reverse to adjust the position of the media
holder. Do not attempt to reposition the media
holders while they are inserted in the media.
P
Move to the front side, and while holding the
media to keep it from falling down to the back
side, lift the media loading lever.
Note:
You can change the media suction on the platen
through the screen operation. Increasing the media
suction lowers the possibility of media falling down.
If it is difficult to pull out the media in the following
procedure, decrease the media suction. Change as
required.
Q
Pull out the media to the following position
depending on the type of media.
Normal feeding procedure
Pull out the media to the near edge of the label on
the platen.
Hold the center of the media in one hand, and
pull it straight out.
Do not pull the media with both hands. This
could cause the media to skew or move around.
Take-up feeding procedure
Pull out the media until it reaches the media
holder.
Follow the steps below to pull out the media.
SC-F10000 Series User's Guide
Basic Operations
70
To Next Page
Loading...
Need help?
General