U
Close the front cover, and then move the left and
right lock levers inward.
V
Set the media information on the screen, and
press OK.
Do the following settings here.
❏ Media: Set the media to use for printing
❏ Roll Winding Direction: How to wind the
loaded media
❏ Media Length: Length of the loaded media
❏ Media Detection: How to detect the width of
the media
When you select Media Settings while no Media
Type is set in Media, the screen to select Media
Type appears. Select the Media Type using the
paper weight of the loaded media as a guideline as
shown below.
Media Type
Paperweight (g/m
2
)
Ultra-Thin 39 or under
Thin 40 to 56
Med-Thick 57 to 89
Thick 90 or over
In Media Detection, set Width Detection.
Normally, leave this On.
See the following for details about Media
Detection.
U “General Settings menu” on page 150
Press OK, to start operations, such as detecting
the loaded media.
W
Follow the on-screen instructions to forward the
edge of the media to the given position as
necessary.
SC-F10000 Series User's Guide
Basic Operations
73
To Next Page
Loading...
Need help?
General