Epson Stylus Pro 3800 - Page 118

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 118
4.3.4.3 AC INLET
1. Remove the BASE, ENCLOSURE. (p111)
2. Disconnect the HARNESS, AC INLET from CN1 on the BOARD ASSY.,
POWER SUPPLY.
3. Cut the cable tie that secures the HARNESS, AC INLET to the BASE,
ENCLOSURE.
4. Remove the screw that secures the grounding wire to the BASE, ENCLOSURE.
 One C.B.(O). 4 x 8 screw (6 ± 1 kgf.cm)
5. Remove the two screws that secure the AC INLET to the BASE, ENCLOSURE.
 Two C.F.S. 3 x 6 screws (6 ± 1 kgf.cm)
6. Remove the AC INLET from the notch of the BASE, ENCLOSURE.
Figure 4-35. Removing the AC INLET
C.F.S. 3x6
CN1
AC INLET
Grounding Wire
cable tie
C.B.(O). 4x8
BASE, ENCLOSURE
HARNESS, AC INLET