Epson Stylus Pro 3800 - Page 121

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 121
6. Remove the two screws that secure the MOTOR ASSY., APG to the FRAME ASSY.,
SUB, RIGHT.
See Figure 4-40.
 Two C.B.S. 3 x 6 screws (9 ± 1 kgf.cm)
7. Turn the MOTOR ASSY., APG in the direction of arrow in
Figure 4-40 to release
the part that contacts with the FRAME ASSY., SUB RIGHT, and remove the
MOTOR ASSY., APG toward inside of the main unit.
See Figure 4-40.
Figure 4-40. Removing the screws from the MOTOR ASSY., APG
When installing the MOTOR ASSY., APG, be careful of the
following.
 The board-attached side must face upward.
 The screwing portions of the MOTOR ASSY., APG must come
to the outside of the main frame.
Overhead view
MOTOR ASSY., APG
main frame
MOTOR ASSY., APG
MOTOR ASSY., APG
Right side of the printer
C.B.S. 3x6