Epson Stylus Pro 3800 - Page 137

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 137
REASSEMBLY
 GUIDE, STACKER, LEFT
1. Install the GUIDE, STACKER, LEFT so that the two points mentioned below are
securely engaged. See Figure 4-59.
2. Slide the GUIDE, STACKER, LEFT toward the rear of the printer.
Figure 4-59. Installing the GUIDE, STACKER, LEFT
Fig. GUIDE, STACKER, LEFT Main unit
A positioning tab positioning hole
B positioning hole hook
C H E C K
P O I N T
Make sure that the cutout of the GUIDE, STACKER, LEFT is
aligned with the screw hole on the main frame.
GUIDE, STACKER, LEFT
A
B