Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 139
STACKER, ASSY.
1. While pressing the stopper of the STACKER, ASSY., put the dowels of the left
rear and right rear of the STACKER, ASSY. into the slits of the rear of the
GUIDE, STACKER, LEFT and GUIDE, STACKER, RIGHT.
2. Put the dowels of the left front and right front of the STACKER ASSY. into the
slits of the front of the GUIDE, STACKER, LEFT and GUIDE, STACKER,
RIGHT.
3. Push in the STACKER, ASSY. to the end.
4. Secure the left and right of the PLATE, STOPPER, STACKER with the screws.
5. Attach the STACKER, C.
6. Close the STACKER, C.
Figure 4-61. Installing the STACKER, ASSY
Left rear Right rear
Right frontLeft front
stopper
GUIDE, STACKER, LEFT
GUIDE, STACKER, RIGHT
STACKER ASSY
To Next Page
Loading...
