Epson Stylus Pro 3800 - Page 148

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 148
12. Tilt the FRAME, PAPER, EJECT, ASSY in the direction shown in the Figure
4-74. Lift up the right side of the FRAME, PAPER, EJECT, ASSY slightly to pass
it over the bump of the FRAME, ASSY, MAIN as shown in the Figure 4-74.
13. Remove the FRAME, PAPER, EJECT, ASSY following the steps shown in the
Figure 4-75.
Figure 4-74. Tilting the FRAME, PAPER, EJECT, ASSY
Figure 4-75. Removing the FRAME, PAPER, EJECT, ASSY
FRAME, PAPER, EJECT, ASSY
FRAME, PAPER, EJECT, ASSY
dowel
2
Remove the FRAME, PAPER,
EJECT, ASSY in the direction of
the red arrow.
Push out the FRAME,
PAPER, EJECT, ASSY
toward the rear.
1
3
FRAME, PAPER, EJECT, ASSY
Pull out the dowel of the
FRAME, PAPER,
EJECT, ASSY.