Epson Stylus Pro 3800 - Page 152

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 152
4.3.9.2 COVER, CR
1. Remove the HOUSING, UPPER. (p107)
2. Remove the two screws that secure the COVER, CR and remove it.
 One C.B.P. 3 x 6 screw (9 ± 1 kgf.cm)
 One C.B.S. 3 x 6 screw (9 ± 1 kgf.cm)
Figure 4-79. Removing the COVER, CR
C A U T I O N
The following are important points when installing the COVER,
CR.
 As different types of screws are used, make sure to reinstall the
correct type of screws at the correct positions.
 Before screwing the unit, make sure that the cables are not
trapped.
 Make sure that the cables of the APG SENSOR are routed
through the cutout of the sponge of the COVER, CR.
Sponge
COVER, CR
Cable of APG SENSOR
Overhead view
COVER, CR
C.B.P. 3x6
C.B.S. 3x6