Epson Stylus Pro 3800 - Page 153

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 153
4.3.9.3 INK, SYSTEM, ASSY.
1. Remove the HOUSING, UPPER. (p107)
2. Remove the three screws that secure the SHIELD PLATE, HOLDER, ASSY.
 Three C.B.S. 3 x 6 screws (9 ± 1 kgf.cm)
3. Slide the SHIELD PLATE, HOLDER, ASSY. toward the rear to remove the two
tabs on the rear side, and remove the SHIELD PLATE, HOLDER, ASSY.
Figure 4-80. Removing the SHIELD PLATE, HOLDER, ASSY.
C A U T I O N
Since the INK, SYSTEM, ASSY. of Epson Stylus Pro 3800/3800C/
3850 and Epson Stylus Pro 3880/3885/3890 has no compatibility, be
careful not to install the wrong one.
Insert the two positioning holes of the SHIELD PLATE, HOLDER,
ASSY. over the guide pins of the FRAME, HOLDER, IC, ASSY., to
secure the SHIELD PLATE, HOLDER, ASSY.
FRAME, HOLDER, IC, ASSY.
positioning points
tabs
SHIELD PLATE, HOLDER, ASSY.
C.B.S. 3x6