Epson Stylus Pro 3800 - Page 159

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 159
16. Remove the two screws that secure the SELECTOR, INK, ASSY. including the
damper, and remove the SELECTOR, INK, ASSY. upward from the CARRIAGE,
ASSY.
 One C.B.P. 2.5 x 8 screw (2 ± 0.5 kgf.cm)
 One C.B.S. 2.5 x 4 screw (2 ± 0.5 kgf.cm)
Figure 4-87. Removing the SELECTOR, INK, ASSY.
C A U T I O N
When installing the SELECTOR, INK, ASSY., make sure not to
mix up the C.B.P. 2.5 x 8 screw and the C.B.P. 2.5 x 4 screws as they
are similar to each other.
A D J U S T M E N T
R E Q U I R E D
Whenever the INK, SYSTEM, ASSY., is replaced, the
corresponding adjustments must be carried out. See Chapter 5
"ADJUSTMENT" (p208).
<Adjustment Item>
1. Reset When INK SYSTEM ASSY Change
C.B.P. 2.5x8
SELECTOR, INK, ASSY.
C.B.S. 2.5 x 4