Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 158
12. Remove the COVER, CR. (p152)
13. Disconnect the all connectors and FFCs from the BOARD ASSY., SUB.
14. Remove the screw that secures the grounding wire of the (MOTOR, INK
SELECTER) to the BOARD ASSY., SUB.
See Figure 4-85.
One C.B.S. 3 x 6 screw (6 ± 1 kgf.cm)
15. Remove the two screws that secure the STRENGTHEN PLATE, CR and remove
it.
See Figure 4-86.
Two C.B.P. 3 x 6 screws (3 ± 0.5 kgf.cm)
Figure 4-85. Removing the BOARD ASSY., SUB
Figure 4-86. Removing the STRENGTHEN PLATE, CR
C A U T I O N
Do not disconnect/insert FFCs from/into the connectors at an angle.
Doing so may damage, short, or break the terminals in the
connector resulting in a breakdown of the elements on the board.
Insert the positioning hole of the STRENGTHEN PLATE, CR over
the guide pin of the CARRIAGE, ASSY. to secure the
STRENGTHEN PLATE, CR. See Figure 4-86.
BOARD ASSY., SUB
C.B.S. 3 x 6
Secures the HARNESS,
Grounding Wire and
BOARD ASSY.,SUB
grounding wire
(MOTOR, INK SELECTOR)
STRENGTHEN PLATE, CR
positioning point
C.B.P. 3 x 6
To Next Page
Loading...
