Epson Stylus Pro 3800 - Page 183

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 183
29. Connect the cables to the CN63, CN69, CN70, CN71 and CN72 on the BOARD
ASSY., MAIN.
30. Push the BASE, ENCLOSURE back into the original position.
31. Route and fold back the FFCs on the COVER, ENCLOSURE, ASSY taking care
of the followings.
 Keep 5 mm or more away from the U-shaped cutout
 Avoid covering the hole shown in Figure 4-125
32. Install the BASE, ENCLOSURE. (p111)
33. Install the INK, SYSTEM, ASSY.. (p153)
34. Install the COVER, CR. (p152)
35. Install the HOUSING, UPPER. (p107)
Figure 4-124. Connecting the Cables
Figure 4-125. Routing the FFCs on the COVER, ENCLOSURE, ASSY
When installing the COVER, CR, make sure that the cables of the
APG SENSOR is routed through the cutout of the sponge of the
COVER, CR.
Sponge
COVER, CR
Cable of APG SENSOR
CN69
CN70
CN71
CN72
CN63
BASE, ENCLOSURE
5 mm
Holes
U-shaped cutout
COVER, ENCLOSURE, ASSY