Epson Stylus Pro 3800 - Page 187

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 187
4.3.10.3 MOTOR, RELEASE, ASSY.
1. Remove the HOUSING, UPPER. (p107)
2. Pull out the BASE, ENCLOSURE. (p111)
3. Disconnect the cables from CN41, CN57, CN61 on the BOARD ASSY., MAIN.
See Figure 4-29.
4. Remove the acetate tapes on the COVER, ENCLOSURE, ASSY. to release the
cables of the MOTOR, RELEASE, ASSY. See Figure 4-131.
5. Release the cables of the parts listed below, which are components in the
MOTOR, RELEASE, ASSY. from the two cable hooks. See Figure 4-132.
 MOTOR ASSY., PF
 MOTOR ASSY., RELEASE
 RELEASE SENSOR
Figure 4-131. Releasing the MOTOR, RELEASE, ASSY. Cables (1)
Figure 4-132. Releasing the MOTOR, RELEASE, ASSY. Cables (2)
Route the cables of the MOTOR, RELEASE, ASSY. with other
cables and secure them with the acetate tapes as shown in Figure
4-131.
COVER, ENCLOSURE, ASSY
acetate tapes
Left rear side of the printer
Left rear side of the printer
cable hooks