Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 188
6. Remove the HARNESS, ENCODER, PF secured to the MOTOR, RELEASE,
ASSY., with the two-sided tape. See Figure 4-133.
7. Remove the three screws that secure the MOTOR, RELEASE, ASSY. See Figure
4-134.
Three C.B.S. 3 x 6 screws (9 ± 1 kgf.cm)
8. Remove the TIMING BELT, PF from the pinion gear of the MOTOR ASSY., PF
and remove the MOTOR, RELEASE, ASSY.
Figure 4-133. Removing the HARNESS, ENCODER, PF
Figure 4-134. Removing the screws from the MOTOR, RELEASE ASSY.
A D J U S T M E N T
R E Q U I R E D
Whenever the MOTOR, RELEASE, ASSY., is replaced, the
corresponding adjustments must be carried out. See Chapter 5
"ADJUSTMENT" (p208).
<Adjustment Item>
1. PF Adjustment
2. EJ Adjustment
Left side of the printer
Two-sided Tape
HARNESS, ENCODER, PF
MOTOR, RELEASE, ASSY.
C.B.S. 3x6
C.B.S. 3x6
C.B.S. 3x6
MOTOR, RELEASE, ASSY.
TIMING BELT, PF
To Next Page
Loading...
