Epson Stylus Pro 3800 - Safety Instructions; Important Safety Instructions

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 193
4.3.11.3 BOARD ASSY., INK MARK
1. Remove the CARRIAGE, ASSY. (p189)
2. From the rear side of the CARRIAGE, ASSY., remove the screw that secures the
HOLDER, DETECTOR, PW.
See Figure 4-142.
 One C.P.B. 1.7 x 8 screw (1.25 ± 0.25 kgf.cm)
3. Disconnect the HARNESS, INK MARK from CN1 connector on the BOARD
ASSY., INK MARK, and remove the BOARD ASSY., INK MARK.
See Figure 4-143.
Figure 4-142. Removing the HOLDER, DETECTOR, PW
Figure 4-143. Removing the BOARD ASSY., INK MARK
Insert the positioning hole of the BOARD ASSY., INK MARK over
the guide pin of the CARRIAGE, ASSY. to secure the BOARD
ASSY., INK MARK. See Figure 4-143.
Rear side
C.P.B. 1.7x8
HOLDER, DETECTOR, PW
CARRIAGE, ASSY.
positioning point
CN1
BOARD ASSY,
INK MARK
HARNESS, INK MARK