Epson Stylus Pro 3800 - Page 194

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 194
4.3.11.4 BOARD ASSY., DETECTOR, PW; B
1. Remove the CARRIAGE, ASSY. (p189)
2. From the rear side of the CARRIAGE, ASSY., remove the screw that secures the
HOLDER, DETECTOR, PW.
See Figure 4-144.
 One C.P.B. 1.7 x 8 screw (1.25 ± 0.25 kgf.cm)
3. Disconnect the HARNESS, PW from CN1 connector on the BOARD ASSY.,
DETECTOR, PW; B, and remove the BOARD ASSY., DETECTOR, PW; B.
See Figure 4-145.
Figure 4-144. Removing the HOLDER, DETECTOR, PW
Figure 4-145. Removing the BOARD ASSY., DETECTOR, PW; B
Rear side
HOLDER, DETECTOR, PW
CARRIAGE, ASSY. C.P.B. 1.7x8
BOARD ASSY., DETECTOR, PW; B
HARNESS, PW
CN1