Epson Stylus Pro 3800 - When handling the ink cartridges

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 195
4.3.11.5 BELT, CR
1. Remove the CARRIAGE, ASSY. (p189)
2. Remove the BELT, CR from the belt holding part on the rear side of the
CARRIAGE, ASSY.
Figure 4-146. Removing the BELT, CR
Make sure to check the following points when installing the BELT, CR.
 Set the BELT, CR so that its lumpy side faces inward.
 Put the both-sides-lumpy part of the BELT, CR into the belt
holding part of the CARRIAGE ASSY.
Both-sides-
lumpy part
Belt holding part
Inner side: lumpy
Outer side: flat
Inner side: lumpy
Outer side: flat
Rear side
BELT, CR
CARRIAGE, ASSY.