Epson Stylus Pro 3800 - Page 203

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 2) 203
4.4.1.4 PAPER, DETECTOR, ASSY.
1. Remove the HOUSING, UPPER. (p107)
2. Pull out the BASE, ENCLOSURE. (p111)
3. Disconnect the cable from CN54 on the BOARD ASSY., MAIN. See Figure 4-29.
4. Remove the acetate tapes on the COVER, ENCLOSURE, ASSY. to release the
cables of the PAPER, DETECTOR, ASSY. (PE SENSOR). See Figure 4-156.
5. Release the cables of the PAPER, DETECTOR, ASSY., from the three cable
hooks. See Figure 4-157.
6. Remove the ASF, ASSY. (p197)
Figure 4-156. Releasing the PAPER, DETECTOR, ASSY. (PE SENSOR) Cables
Figure 4-157. Releasing the PAPER, DETECTOR, ASSY. Cables
Route the cables of the PAPER, DETECTOR, ASSY. with other
cables and secure them with the acetate tapes as shown in Figure
4-156.
Right rear side
acetate tape
COVER, ENCLOSURE, ASSY.
Right rear side
cable hooks