Epson Stylus Pro 3800 - Page 202

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 2) 202
4.4.1.3 ASF SENSOR
1. Remove the HOUSING, UPPER. (p107)
2. Remove the ASF, ASSY. (p197)
3. Disengage the two tabs of the FLAG, DETECTOR, ASF on the left side of the
ASF, ASSY. from the inside, and remove the FLAG, DETECTOR, ASF.
4. Disengage the four tabs of the ASF SENSOR, and remove the ASF SENSOR.
Figure 4-154. Removing the FLAG, DETECTOR, ASF
Figure 4-155. Removing the ASF SENSOR
Be sure to align the two grooves of the FLAG, DETECTOR, ASF
with the ribs of the LD ROLLER SHAFT to install the FLAG,
DETECTOR, ASF.
FLAG, DETECTOR, ASF
grooves
ribs
FLAG, DETECTOR, ASF
ASF SENSOR