Epson Stylus Pro 3800 - Page 73

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
TROUBLE SHOOTING Remedies for Error Messages 73
PAPER SENSOR ERROR
PRESS THE BUTTON
LOAD THE CORRECT PAPER
An error has occurred while the Ink Mark sensor is reading the print pattern for
adjustment.
Press the Cancel/Reset button and load a different type of paper.
CLEANING ERROR
PRESS THE CANCEL/RESET
BUTTON
Clogged nozzles cannot be cleared even after running head cleaning cycle a
predetermined number of times.
Press the Cancel/Reset button to clear the error, and retry the head cleaning.
CLEANING ERROR
PRESS THE
DOWN BUTTON
AND REMOVE
THICK PAPER
Head cleaning was attempted when board paper had been fed. Remove the board paper and close the Board Paper Tray.
PAPER SETTING ERROR
CHECK PAPER SOURCE IN
THE DRIVER SETTINGS
AND LOAD PAPER
CORRECTLY
The ASF is specified as the paper source of the received job, but paper has
been loaded on the front or rear manual feed tray.
Cancel the job, or press the Paper Feed/Down button to eject the paper.
Feeding paper from the ASF is attempted using the operation panel after
receiving a job specifying the front or rear manual feed tray as its paper source.
Message on LCD Description Remedy