Epson Stylus Pro 3850 - Page 130

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 130
4.3.6.4 MAINTENANCE CARTRIDGE SENSOR
1. Remove the HOUSING, UPPER. (p107)
2. Disconnect the connector from the MAINTENANCE CARTRIDGE SENSOR.
See Figure 4-51.
3. Open the COVER, WB. See Figure 4-5.
4. Disengage the four tabs that secure the MOUNTING PLATE, DETECTOR,
LOWER with a precision screwdriver or similar tools accessing from the bottom
of the main unit, and remove the MOUNTING PLATE, DETECTOR, LOWER.
See Figure 4-51.
5. Disengage the two hooks that secure the MAINTENANCE CARTRIDGE
SENSOR to the MOUNTING PLATE, DETECTOR, LOWER, and remove the
MAINTENANCE CARTRIDGE SENSOR.
See Figure 4-52.
Figure 4-51. Removing the MOUNTING PLATE, DETECTOR, LOWER
Figure 4-52. Removing the MAINTENANCE CARTRIDGE SENSOR
- Bottom -
MOUNTING PLATE, DETECTOR, LOWER
MAINTENANCE
CARTRIDGE SENSOR
connector
Releasing the tabs
hooks
MOUNTING PLATE, DETECTOR, LOWER
MAINTENANCE CARTRIDGE SENSOR