Epson Stylus Pro 7000 - Page 119

EPSON Stylus Pro 7000 Revision B
Disassembly & Assembly Disassembly Flow 119
4.2.1.7 Paper Guide L2 Removal
1. From the front, remove four white screws (Truss:M4x6), and remove the
Paper Guide L2.
Figure 4-18. Paper Guide L2 removal on right side
Figure 4-19. Paper Guide L2 removal on left side
Two
screws
Paper
Guide
L2
Paper
Guide
L2
Two
screws
When replacing the Paper Guide L2, make sure the five tabs at
the top of the guide slide in between the metal and black
cushion. Then secure with the screws.
If just one of the tabs is not inserted properly, roll paper will
most likely still feed normally, but cut sheets might not.
Paper
Guide L
Paper
Guide L2
Five tabs