Epson Stylus Pro 7000 - Page 120

EPSON Stylus Pro 7000 Revision B
Disassembly & Assembly Disassembly Flow 120
4.2.1.8 Roll Paper Cover Removal
1. Open the Roll Paper Cover.
2. Remove two white screws (CPS:M4x8) securing the black spindle support
on the left, and then remove the spindle support.
Figure 4-20. Roll Paper Cover removal on left side
3. Remove two white screws (CPS:M4x8) securing the gray spindle support
on the right, and then remove the spindle support.
Figure 4-21. Roll Paper Cover removal on right side
4. Remove the cover brake pin from either the left or right side, and remove
the cover.
Two
screws
Spindle
support
Brake pin
Roll
Paper
Cover
Two
screws
Spindle
support
Brake pin
Roll
Paper
Cover