Saving Sets of Media Settings
You can store sets of media settings for each type of media you use. This lets you quickly select all the
necessary settings whenever you print on that media type.
The media settings include the options selected and stored for each media bank or RIP setting you
created.
Note: Make sure that you loaded the media type for which you are selecting settings.
1. Press the Menu button on the product control panel.
2. Select the Media Setup menu and press the OK button.
3. Press the up or down arrow button to select Customize Settings and press the OK button.
4. Press the up or down arrow button to select a number for the set of media settings (from 1 to 30) and
press the OK button.
5. Select Setting Name and press the OK button.
6. Press the up or down arrow button to display the letters and symbols you can use to name the media
set. When you see the desired character, press the right arrow button to move to the next character
position and repeat this step as necessary to complete the setting name. When you finish, press the
OK button.
Note: If you need to delete the previous character, press the left arrow button.
7. Press the up or down arrow button as necessary to select each available media setting and press
the OK button. If necessary, press the back button to return to the menu to select additional
settings.
Parent topic: Media Handling
Related tasks
Loading Media
Printable Area and Media Size Checking
The left and right edges of media recognized by your product vary depending on the Media Size Check
setting.
• When the Media Size Check setting is turned on, your product automatically detects the left and right
edges of the media within 0.2 inches (5 mm), as long as the media holding plates are attached
correctly.
38
To Next Page
Loading...
