Caution: Once part A is hidden, do not turn the handle further or you may damage the roll core
holder. If part A remains visible after turning the handle fully, rewind the handle, loosen the fixing
screw, and reload the roll core on the auto take-up reel.
Parent topic: Using the Auto Take-up Reel
Take Up with the Printable-Side-In
After attaching the roll core on the auto take-up reel, follow these steps to take up media with the
printable side in.
1. Guide your loaded media over the media guide bar and behind the roll core, then attach the media to
the roll core with tape as shown here. Begin with the center piece of tape, pulling the media straight
forward before attaching the tape. Then pull the media to each side as you attach the tape on each
side.
Note: Make sure the media lays flat across the roll core without any gaps. If necessary, add more
tape or reattach the tape so the media is taken up correctly.
55
To Next Page
Loading...
