Options Description
Tension Measurement Selects how often tension is measured and automatically
adjusted:
Periodically: recommended for most media
Every page: provides more precise tensioning (but slower
printing)
Feeding Tension Select Auto for most media.
When you select Manual, you can set a value from 0 to 40.
If media creases, set the value higher than Lv28. If banding
appears, set the value lower than Lv28.
When Media Size Check is off, select Manual and set the
value based on the media width.
Take-up Tension Select Auto for most media.
When you select Manual, you can set a value from 1 to 6.
If media wrinkles, banding appears, or ink sticks to the
back of the take-up roll, set the value lower than Lv3. If
thick media cannot be wound correctly, set the value higher
than Lv3.
Prevent Sticking Select On only if the media sticks to the platen when the
printer is turned on or when printing starts.
Restore Settings Returns all RIP settings to their default values.
Print Prints the contents of media setting banks 1 to 30
Parent topic: Using the Control Panel Menus
Related tasks
Loading Media
Saving Sets of Media Settings
Adjusting the Media Feed
Aligning the Print Head
Adjusting Heating and Drying During Printing
73
To Next Page
Loading...
