For information on loading the media into the
auto take-up reel unit, see:
U “Using the Auto Take-up Reel Unit” on
page 35
Note:
If you would prefer to print from the very start of the
roll, press the u button in the control panel to
rewind the media slightly.
Be sure, however, to stop rewinding before the
leading edge of the media is over the cutter groove
(on the pressure roller side).
P
Attach the media holding plates at either side of
the media.
First, position the plates so that the edges of the
media are in the centers of the round holes. Next,
adjust the position the white line is visible in the
square window and push the plates down to lock
them in place.
SC-S30600 Series User's Guide
Basic Operations
26
To Next Page
Loading...
