Item Parameter Explanation
Print Nozzle Pattern
Off Choose the frequency with which the printer prints a nozzle test pattern:
never (Off) or once every 1 to 10 pages. Periodic test patterns will not be
printed while Off is selected. To print a test pattern at the top of every 1 to
10 pages, select an option between 1 and 10. When printing is complete,
you can visually inspect the pattern to determine whether there may be
faint or missing colors in the preceding or following printout.
1 to 10 pages
Periodical Cleaning Off Choose the frequency with which the printer performs head cleaning:
never (Off) or after 1 to 24 hours. Periodic head cleaning will not be
performed while Off is selected. If a value between 1 and 24 hours is
selected, auto head cleaning will be performed after the specified number
of hours. If printing is in progress or the printer is in sleep mode when the
specified time has elapsed, Periodical Cleaning will only be performed
after printing is complete or the printer is reactivated.
The following reset the timer:
❏ Turning the printer on.
❏ Choosing another option for this item.
❏ Manually performing head cleaning using All Nozzles.
Note that even when Off is selected for Periodical Cleaning, the printer will
automatically clean the print head at a fixed interval after printing to keep
the nozzle from clogging.
1 to 24 hours
Cleaning Cycle
Off Choose the frequency with which the performs auto head cleaning: never
(Off) or once every 1 to 10 pages. Head cleaning will not be performed
while Off is selected. Select 1 to 10 to perform head cleaning before the
specified number of pages is printed.
1 to 10 pages
Heat Off Timer 15 to 240 minutes You can turn off the heaters automatically when no errors are detected
and no print jobs are in progress. This option is used to choose the interval
before the heaters turn off automatically.
The printer will enter sleep mode when the Heat Off Timer expires. In sleep
mode, the control panel turns off and the internal motors and other
components consume less power. If an optional additional print drying
system is installed, it will turn off automatically.
To reactivate the control panel display, press any button in the control
panel except P. The control panel display will however turn off again if no
operations are performed for another 30 seconds under these conditions.
The printer and heaters are only fully reactivated when a print job is
received, the media loading lever is used, or another operation involving
printer hardware is performed.
Restore Settings Yes
Select Yes to restore all items in the Printer Setup menu to their default
settings.
No
The Maintenance Menu
The Maintenance menu can be accessed directly by pressing the # button.
SC-S30600 Series User's Guide
Using the Control Panel Menu
80
To Next Page
Loading...
