E
Fully insert the cartridge, keeping the color label
to the front.
Match the color of the cartridge to the color of the
label on the printer.
F
Lower the lock lever to engage the latch.
Repeat steps 2 to 6 to replace other ink cartridges.
c
Important:
❏ Install all ink cartridges into each slot.
You cannot print if any of the slots are
empty.
❏ Ink cartridges inserted in the printer
should be removed and shaken
thoroughly as described in Step 4 about
once every three weeks.
Parts That Are Periodically
Replaced
The following parts require periodic replacement.
Print head: The time until the print head needs to be
replaced with the conditions of use.
When replacing the print head, you will also need to
replace the dumper kit and carriage encoder.
The message Print head is nearing end of service life. is
displayed in the control panel as the time for
replacement draws near. The printer can still be used
while this message is displayed.
Print head life varies with operating conditions. Base the
decision to replace the print head on the quality of the
print results.
Contact your dealer or Epson Support for information
on replacing components.
Component status can be printed by selecting Print
Status Sheet in the setup menu.
U “The Printer Status Menu” on page 82
SC-S30600 Series User's Guide
Maintenance
68
To Next Page
Loading...
