Setting Name
Name the media setting bank. Using distinctive names
makes it easier to select banks for use.
A
Select Setting Name and press the Z button.
B
Use the d/u buttons to display letters and
symbols. When the desired character is
displayed, press the r button to select the next
entry position.
Mistakes can be erased by pressing the l button
to delete the previous character and move the
cursor back one spot.
C
After entering the name, press the Z button.
Feed Adjustment
Feed Adjustment is used to correct banding (horizontal
banding, lines, or strips of uneven color).
The Feed Adjustment menu contains two options:
Auto and Manual.
Auto feed adjustment adjusts the feed automatically
using data collected by a sensor while a test pattern is
printed.
In manual feed adjustment, the user visually inspects
print results and enters a correction by hand.
This section details the steps involved in auto feed
adjustment.
Adjust the feed manually if you feel that auto feed
adjustment has not completely resolved the problem.
For more information on manual feed adjustment, see
U “Feed Adjustment (Manual Feed Adjustment)” on
page 47.
Note:
Feed Adjustment varies with the media used. Load the
media for which feed adjustment is required under the
same conditions as the actual print job. For example, if
you are using the auto take-up reel unit for printing, the
auto take-up reel unit should also be used for feed
adjustment.
Furthermore the media must be loaded and feed
adjustment performed again after the heavy roll media
system is installed even if feed adjustment has already
been performed using standard roll media system.
Feed adjustment is not available under the following
conditions:
❏ The media is transparent or colored.
❏ The printer is exposed to direct sunlight or
interference from other ambient light sources.
Shade the printer from sources of interference.
❏ 2.5 is selected for Platen Gap in the setup menu.
Choose another option for Platen Gap.
Auto feed adjustment may also fail to produce the
expected results if the nozzles are clogged. Perform head
cleaning to remove any clogs.
A
Use the d/u buttons to select Feed Adjustment
and press the Z button.
B
Select Auto and press the Z button.
C
Press the Z button to print a test pattern and
perform auto feed adjustment.
Platen Gap
Adjust the platen gap (the gap between the print head
and the media) if print results are smudged.
A
Use the d/u buttons to select Platen Gap and
press the Z button.
B
Use the d/u buttons to select the desired setting
and press the Z button.
C
Press the y button to return to the customize
settings menu.
SC-S30600 Series User's Guide
Basic Operations
42
To Next Page
Loading...
