Cutting Media
Use a cutter (available in the market) to cut the media
when printing is complete. This section described how
to use a cutter to cut the media.
!
Caution:
The heaters and media holding plate may be hot;
observe all necessary precautions. Failure to
observe the necessary precautions could result in
burns.
Buttons that are used in the following settings
A
Confirm that the printer is ready to print.
B
Press the button and the Z button. The
printer will feed the trailing edge of the printed
media to a position over the cutter groove.
If you have printed the amount of media
remaining, press the u button to rewind the
media so that this information will remain on the
roll after the media is cut.
C
Remove the media holding plates.
SC-S30600 Series User's Guide
Basic Operations
34
To Next Page
Loading...
