D
Cut the media with the cutter.
Pass the blade of the cutter down the cutting
groove.
Note:
If you are using the auto take-up reel unit, set the Auto
switch on the auto take-up reel unit to Off before using
the Manual switch to position the media over the cutting
groove.
Removing Media
You can now remove the media from the roll holders. To
remove the media, reverse the steps you followed to load
it.
Using the Auto Take-up
Reel Unit
Media Loading and Take Up
The auto take-up reel unit automatically takes up media
as it is printed, improving the efficiency of unmanned
operation.
The auto take-up reel unit for this printer can take up
media in either of the following directions.
Counterclockwise Clockwise
Counterclockwise take up places the printed surface on
the outside of the roll.
Clockwise take up places the printed surface on the
inside of the roll.
The explanation that follows uses the supplied auto
take-up reel unit for illustrative purposes, but the same
procedure can be followed when using the optional auto
take-up reel unit for heavy media.
SC-S30600 Series User's Guide
Basic Operations
35
To Next Page
Loading...
