Item Parameter Explanation
Print Start Position 0 to 800 mm (0.00
to 32.00 inch)
Adjust this parameter if you want to print from the near center of the
media or if you want to shift the printed area left from the Side
Margin(Right) setting. The area between the right edge of the media and
Print Start Position is left blank. If a value is selected for Side
Margin(Right), an additional area corresponding to the width selected
for Side Margin(Right) will be left blank. The position from which the this
parameter is measured varies with the option selected for Media Size
Check.
On selected for Media Size Check: The right edge of the media.
Off selected for Media Size Check: The default right edge reference
position (as far as the platen past the center of the label on the pre-heater).
U “Printable area” on page 49
Media Size Check
On
Choose whether the printer automatically detects (On), or does not
automatically detect (Off), the edges of the media. Try Off if the printer
displays a Media Size Error when the media is correctly loaded. Note,
however, that the printer may print beyond the edges of the media when
Off is selected. Ink used outside the edges of the media will stain the inside
of the printer. We generally recommend to operate with this setting set to
On.
Off
Media End Check
On
Choose whether the printer automatically detects (On) or does not
automatically detect (Off), the end of the media. Try Off if the printer
displays Media Out when the media is correctly loaded. We generally
recommend to operate with this setting set to On.
Off
Media Skew Check
On When skewed media is detected, the printer will either stop printing and
display an error (On) or continue printing (Off). On is recommended in
most circumstances, as skewed media may cause the printer to jam.
Off
Auto Nozzle Check
Nozzle Check Cycle
Off
Choose the frequency with which the printer performs an Auto Nozzle
Check: never (Off) or once every 1 to 10 pages. Auto nozzle checks will not
be performed while Off is selected. If 1 to 10 is selected, the printer will
automatically checks for clogs at the specified interval by scanning a test
pattern with a sensor as it is being printed.
Note that Auto Nozzle Check is not capable of detected all types of clog.
In addition, Auto Nozzle Check is not available under the following
conditions:
❏ The media is transparent or colored.
❏ The printer is exposed to direct sunlight or interference from other
ambient light sources.
Shade the printer from sources of interference.
❏ 2.5 is selected for Platen Gap in the setup menu.
Choose another option for Platen Gap.
1 to 10 pages
Options When
Clogged
Continue Printing Choose how the printer responds when an auto nozzle check detects
clogged nozzles.
If Continue Printing is selected, the printer will display Nozzle Clog
Detected but keep printing. Perform head cleaning if you judge it
necessary on inspecting the print results.
If Stop Printing is selected, the printer will display Nozzle Clog Detected
and pause printing. Inspect the print results and choose whether to
resume or suspend printing according to the extent of the clog.
Stop Printing
SC-S30600 Series User's Guide
Using the Control Panel Menu
79
To Next Page
Loading...
