3-22 Disassembly and Assembly Rev.C
Confidential
Install with the following steps:
1. Attach the autocutter unit in its installation position. Then, align the two dowels on the
frame assembly with the two slits in the autocutter unit.
2. Set the autocutter unit to the user’s position (partial cut or full cut).
To select partial cut: adjust the dowel to the position marked P.
To select full cut: adjust the dowel to the position marked F.
3. Secure the autocutter unit with the two S4 screws.
Note:
❏
When tightening the screws, do not deform the frame assembly. This can decrease the sharpness of the
cutter.
❏
Do not tighten the autocutter unit when the dowels are not properly engaged. This can also decrease
the sharpness of the cutter.
Dowel
To Next Page
Loading...
