Rev.C Disassembly and Assembly 3-21
TM-L90 Service Manual
Confidential
Autocutter Unit
1. Users may choose between partial cut and full cut by adjusting the autocutter unit to the
desired position. Check the part shown below to see if the autocutter is set to full cut or
partial cut. When you install the autocutter unit, return the unit to the user’s position.
2. Remove the two S4 screws.
3. Remove the autocutter unit.
Note:
When you need to disassemble or assemble the autocutter unit further, see page 3-39 for instructions.
The dowel positions are marked
“F” and “P.”
To select partial cut: adjust the
dowel to the position marked P.
To select full cut: adjust the
dowel to the position marked F.
Dowel
S4
Autocutter unit
Frame assembly
To Next Page
Loading...
