101
Appendix
Paper Specifications
Paper width 58 mm Paper width 80 mm
Paper types Specified thermal paper
Form Roll paper
Size Roll paper diameter 83 mm {3.27"} maximum
Roll paper core Outside: 18 mm {0.71"}
Roll width when taken up 58 + 0.5/-1.0 mm {2.28 + 0.02/-0.04"} 80 + 0.5/-1.0 mm
Paper width 57.5 ± 0.5 mm {2.26 ± 0.02"} 79.5 ± 0.5 mm
Paper thickness Maximum of 80 μm, minimum of 48 μm
Specified original paper type TF50KS-EY, TF60KS-E NIPPON Paper Industries Co., Ltd.
PD160R, PD190R OJI Paper Mfg. Co., Ltd.
P220AGB-1 Mitsubishi Paper Mills Limited.
AP45KS-ND, AP50KS-ND Jujo Thermal Oy
F50417(55), F50417(48) Mitsubishi HiTec
KT55FA, KT48FA, KT55PF, KT48PF Koehler Paper Group
• Paper must not be pasted to the roll paper core.
• To keep the print quality, it is recommended to change the print densities for each roll paper.
See "Software Settings" on page 48.
• U
se of thermal paper with a pre-printed recording surface should be avoided. Using it can cause
the thermal head to stick to the thermal paper surface during printing, and cause printing
failure and other problems. The pre-printing also can result in reduced print density. Using
thermal paper with a pre-printed recording surface, pre-printing should be done in accordance
with the conditions (ink type, printing and other conditions) recommended by the paper
manufacturer, and the thermal paper should be checked to ensure that there is no faulty
printing, loss of print density, or other problems.
To Next Page
Loading...
Need help?
General