74
Chapter 3 Advanced Usage
Resetting the Interface Settings
Follow the steps below to restore the network settings to the factory default.
1
Turn off the printer and close the roll paper cover.
2
If the bottom cover is attached, remove the cover.
See "Removing the Covers" on page 92 for details on removing the bottom cover.
3
Hold down the status sheet button while turning on the printer.
A message is printed indicating that resetting is being performed, and the printer restarts.
You can return the interface settings to their defaults from the Interface Setup mode. See "Interface
Setup Mode" on page 68 for details on the Interface Setup mode.
To Next Page
Loading...
Need help?
General