51
Chapter 3 Advanced Usage
Print density
Selectable from 70% to 120% (5% increment)
Initial setting: 100%
Depending on the paper type, it is recommended to set the print density as shown in the table below for the best
print quality.
Print speed
Selectable from levels 1 to 13 (Slow ~ Fast)
Initial setting: level 13
Thai characters print mode
• Thai 1 pass (initial settings)
• Thai 3 pass
Character code table defaults
Selectable from 43 pages including user defined page
Initial setting: PC437: USA, Standard Europe
International character defaults
Selectable from 18 sets
Initial setting: USA
Supported papers Print density
TF50KS-EY, TF60KS-E, PD160R,
PD190R, P220AGB-1, AP45KS-ND,
AP50KS-ND, KT55PF
100%
P5047(48) 105%
KT48FA, KT55FA, KT48PF, P5047(55) 110%
When the print density level is increased, print speed may be reduced.
Depending on print conditions, such as print duty, print head temperature, and data transmission
speed, print speed is automatically adjusted, which may cause white lines due to intermittent print
(the motor sometimes stops). To avoid this, keep the print speed constant by setting it lower.
To Next Page
Loading...
Need help?
General