1. Safety
2 Safety and Installation (T, VT / EPSON RC+ 7.0) Rev.15
1.2 Design and Installation Safety
Only trained personnel should design and install the robot system. Trained
personnel are defined as those who have taken robot system training held by the
manufacturer, dealer, or local representative company, or those who understand the
manuals thoroughly and have the same knowledge and skill level as those who have
completed the training courses.
To ensure safety, a safeguard must be installed for the robot system. For details on
the safeguard, refer to the Installation and Design Precautions in the Safety chapter
of the EPSON RC+ User’s Guide.
The following items are safety precautions for design personnel:
WARNING
■
Personnel who design and/or construct the robot system with this
product must read the
Safety chapter in the EPSON RC+ User’s
to understand the safety requirements before designing and/or
constructing the robot system.
Designing and/or constructing the
robot system without understanding the safety requirements is
extremely hazardous,
and may result in serious bodily injury and/or
e equipment damage to the robot system.
■
robot system must be used within the environmental conditions
ed in their respective manuals. This product has been
designed and manufactured strictly for use in a normal indoor
environment.
Using the product in an environment that exceeds the
specified environmental conditions may not only shorten the life cycle
o
f the product but may also cause serious safety problems.
■
The robot system must be used within the installation requirements
described in the manuals.
Using the robot system outside of the
installation requirements may not only shorten the life
cycle of the
product but also cause serious safety problems.
Further precautions for installation are mentioned in the following manuals.
Please read this chapter carefully to understand safe installation procedures before
installing the robots and robotic equipment.
1.2.1 Relevant Manuals
Refer
This manual : 2. Installation
Manipulator manual : Setup & Operation 3. Environment and Installation
To Next Page
Loading...
