2. Installation
Safety and Installation (T, VT / EPSON RC+ 7.0) Rev.15 45
2. Installation
This chapter contains precautions for safe and accurate installation of the robot
system.
The workflow for installing the robot system is described in 2.1 Outline from
Unpacking to Operation of Robot System. For unpacking, transportation, and
installation, refer to the respective section and the Manipulator manuals.
System Example
*1 EPSON RC+ 7.0 supports the following OS
Windows 7 Professional Service Pack 1
Windows 8.1 Pro (EPSON RC+7.0 Ver.7.1.0 or later)
Windows 10 Pro (EPSON RC+7.0 Ver.7.2.0 or later)
*2 Either teaching pendant is available.
*3 If connecting to T series or VT series Manipulator, dedicated convert cable is
necessary.
To Next Page
Loading...
