EasyManua.ls Logo

Epson WF-6090 - Network Interface Specifications

Epson WF-6090
252 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Network Interface Specifications
Wi-Fi
Standard IEEE 802.11 b/g/n; complies with either IEEE 802.11 b/g or IEEE
802.11 b/g/n, depending on purchase location
Security WEP (64/128 bit)
WPA2-PSK (AES); complies with WPA2 with support for
WPA/WPA2 Personal
WPA2-Enterprise
Frequency range 2.4 GHz
Coordination modes Infrastructure mode
Ad hoc mode; no supported by IEEE 802.11 n
Wi-Fi Direct; not supported for IEEE 802.11b
Note: Wi-Fi Direct Simple AP mode available with a Wi-Fi
infrastructure or Ethernet connection.
Ethernet
Standards IEEE802.3i (10BASE-T)
IEEE802.3u (100BASE-TX)
IEEE802.3ab (1000BASE-T)
IEEE802.3az (Energy Efficient Ethernet); connected device should
be IEEE802.3az compliant
Communication mode Auto, 10Mbps Full duplex, 10Mbps Half duplex, 100Mbps Full
duplex, 100Mbps Half duplex
Connector RJ-45
Note: Use a category 5e or higher STP (shielded twisted pair) cable to prevent risk of radio interference.
Security Protocol
IEEE802.1X; connected device must be IEEE802.1X compliant
233

Table of Contents

Other manuals for Epson WF-6090

Related product manuals