You see this screen:
4. Press the OK button to view the SSID (Wi-Fi network name) and password.
5. Use your computer or wireless device to select the Wi-Fi network name (SSID) displayed on the
LCD screen, and enter the password shown.
6. Press the OK button to exit.
You see either the AP or D connection symbol on the LCD screen and should be able to print directly
to your product from your computer or device.
Note: If the AP or D connection symbol is not displayed on the LCD screen, Wi-Fi Direct mode is not
enabled. Repeat these steps to try again.
Parent topic: Wi-Fi Direct Mode Setup
Related references
Status Icons
Changing the Wi-Fi Direct Password
You can change the Wi-Fi Direct password from the default to improve the security of your Wi-Fi Direct
connections.
Note: If you change the Wi-Fi Direct password, you cannot use the built-in NFC functionality to connect
to the product. If you have already connected devices or computers to your product via Wi-Fi Direct, they
are disconnected when you change the password.
1. Press the arrow buttons to select Wi-Fi Setup and press the OK button.
36
To Next Page
Loading...
