USB I/F Timeout Setting:
Specify the length of time in seconds that must elapse before ending USB communication with a
computer aer the printer receives a print job from a PostScript printer driver or PCL printer driver.
If the job ending is not clearly
dened
from a PostScript printer driver or PCL printer driver, it can
cause endless USB communication. When this occurs, the printer ends communication
aer
the
specied time has elapsed. Enter 0 (zero) if you do not want to end communication.
Related Information
& “Loading Papers” on page 25
& “Printing JPEG Files from a Memory Device” on page 92
& “Printing PDF or TIFF Files from a Memory Device” on page 93
Network Settings
Select the menus on the control panel as described below.
Settings > General Settings > Network Settings
You cannot change settings that have been locked by your administrator.
Wi-Fi Setup:
Set up or change wireless network settings. Choose the connection method from the following and then
follow the instructions on the LCD panel.
❏ Router
❏ Wi- Fi Dire c t
Wired LAN Setup:
Set up or change a network connection that uses a LAN cable and router. When this is being used, Wi-
Fi connections are disabled.
Network Status:
Displays or prints the current network settings.
❏ Wired L AN/ Wi-Fi Sta tu s
❏ Wi- Fi Dire c t St atu s
❏ Email Server Status
❏ Print Status Sheet
Connection Check:
Checks the current network connection and prints a report. If there are any problems with the
connection, see the report to solve the problem.
Advanced:
Make the following detailed settings.
❏ Device Name
❏ TCP/IP
User's Guide
Preparing the Printer
55
To Next Page
Loading...
