227
LCD screen message Condition/solution
Unsupported Paper Cassette Units
have been installed. Turn the power
off and uninstall. For details, see
your documentation.
Unsupported optional paper cassette units are installed.
Remove the unsupported units.
Cannot print because XX is out of
order. You can print from another
cassette.
Turn the product off and then back on again. Reinsert the
indicated paper cassette. If the error persists, contact Epson for
support.
Maintenance Roller in XX is nearing
the end of its service life.
The maintenance rollers need to be replaced periodically for
optimal performance. (Paper may not feed correctly from the
paper cassette or rear paper feed when a maintenance roller is
near the end of its service life.)
Maintenance Roller in XX is at the
end of its service life. Replace it and
reset the maintenance roller counter.
Replace the maintenance rollers and reset the maintenance
roller counter for the paper cassette for which you replaced the
maintenance rollers.
Maintenance roller in the Rear Paper
Feed is at the end of its service life.
For details, see your documentation.
Contact Epson for support.
You need to replace Ink Cartridge(s). Replace the indicated ink cartridges.
The time for maintenance is
approaching. Contact Epson
Support.
Do not attempt to perform maintenance on your own. Contact
Epson for support.
Maintenance required. Contact
Epson Support.
Do not attempt to perform maintenance on your own. Contact
Epson for support.
Paper Setup Auto Display is set to
Off. Some features may not be
available. For details, see your
documentation.
AirPrint is not available when the Paper Setup Auto Display
setting is disabled. Set the Paper Setup Auto Display setting to
On.
The combination of the IP address
and the subnet mask is invalid. See
your documentation for more details.
There is a problem with the network connection to your product.
Set up your product on the network again.
To use cloud services, update the
root certificate from the Epson Web
Config utility.
Access the Web Config utility and update the cloud service root
certificate.
To Next Page