QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x) 11
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
Basic Setup
System (LAN) – System Configuration Wizard
The System Configuration Wizard allows the administrator to define the QX Gateway’s Local Area Network settings and to specify regional configuration
settings to make QX Gateway operational in its LAN. The System Configuration Wizard MUST be run upon QX Gateway's first startup to make sure
that it works properly in its network environment. The Wizard allows navigating through the following basic configuration parameters and settings:
• System Configuration (see below)
• DHCP Settings for the LAN Interface
• Regional Settings and Preferences (see below)
DHCP Settings for the LAN are described in the chapters below.
The LAN configuration and regional settings will be described
later in this chapter.
Please Note:
It is strongly recommended to leave the
factory default settings if their meanings are not fully clear
to the administrator.
Fig.II- 3: System Configuration Wizard – Getting Started page
System Configuration
page contains the host name, IP
address and Subnet Mask information about the QX Gateway
LAN interface. These settings make QX Gateway available to the
internal network.
The System Configuration page offers the following input
options:
Host Name requires a host name for the QX Gateway device.
Domain Name requires the LAN side domain name which the
QX Gateway belongs to.
IP Address requires the QX Gateway host address for the LAN
interface.
Subnet Mask requires the QX Gateway hosts’ Subnet Mask.
Fig.II- 4: System Configuration Wizard - System Configuration page
To Next Page
Loading...
Need help?
General