Epygi QX series Administrator's Guide

QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x) 80
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
Blocked IPs
When
Blocked IP List
is used, traffic from specific hosts may be
blocked, no matter what services are opened in the other filters. NO
traffic will be allowed to the specified hosts. The Blocked IP List
service has a higher priority if the same host is also listed in the
Allowed IP List table.
Fig.II- 110: Filtering Rules page
Allowed IPs
Allowed IP List
allows trusted hosts to reach your network and
vice versa. It is an exception to other rules and only all services may
be allowed for a single host.
Fig.II- 111: Filtering Rules page
The table displayed on the bottom of this page shows the filters selected above, specified by their State (enabled or disabled), the selected Service, the set
Action (allowed or blocked), the IP addresses the filters apply to (if Restricted) and the destination of port forwarding (Redirect to, in case of Incoming
Traffic/Port Forwarding). With the exception of View All, the table offers the following functional buttons:
• Enable is used to enable the rule. If no records are selected the error message “No record(s) selected” will appear.
• Disable is used to disable the rule. If no records are selected the error message “No record(s) selected” will appear.
• Add opens a filter specific page where new rules may be defined by a Service, an Action, a Restriction to certain IP address(es) or IP groups, and if
adding a rule for Incoming Traffic/Port Forwarding, the destination IP address for Forwarding.
The page to add a rule for Incoming Traffic/Port Forwarding offers the following input options:
Service includes a list of possible services to be configured. All user-defined services also will be displayed in this list.
Action includes possible actions to setup the rule.
Forward to IP requires the destination IP address where traffic should be transferred to if it comes from the restricted host. The IP address defined in this
field will be ignored for blocked action of the Incoming Traffic/Port Forwarding rule.
Please Note: It is not allowed to forward incoming packets when the NAT service is disabled on the QX gateway.

Epygi QX series Specifications

General

Brand	Epygi
Model	QX series
Category	PBX
Language	English