QX50/QX200/QX2000; (SW Version 6.0.x) 12
QX50/QX200/QX2000 Manual II: Administrator’s Guide
Regional Settings and Preferences
settings specific to the location of the QX IP PBX. This is
important for the functionality of the voice subsystem.
The Regional Settings and Preferences page has two drop
down lists to select the Your Locale (location) and a
corresponding Timezone. QX IP PBX
Savings (DST) correction if it is available for the selected time
zone.
This page also has a manipulation radio button group to
choose:
• System Language – selection is available only when the
custom Language Pack has been uploaded and it is used
to enable custom language for system voice messages or
returning back to the default language English.
Fig.II- 5: System Configuration Wizard - Regional Settings page
Emergency Codes
PSTN Access Code Settings
are
used to configure the emergency dial plan.
The Emergency Codes text field requires the PSTN numbers
of the emergency or lifeline services. Multiple emergency
codes, separated by commas, can be inserted in this field. For
each emergency code, a routing pattern will be generated in
the Call Routing Table, which will allow faster and easier calls
to emergency destinations.
The PSTN Access Code drop down list allows you to select the
prefix code for accessing the PSTN line in the routing mode.
Dialing the digits inserted in this text field will provide the
PSTN dial tone when dialed from the handset.
Fig.II- 6: System Configuration Wizard - Emergency Codes and PSTN Access Code Settings page
Internet (WAN) - Internet Configuration Wizard
The Internet Configuration Wizard (Uplink Configuration Wizard in case of QX2000) allows the administrator to configure the WAN interface settings
and to adjust QX IP PBX’s connectivity with an external network. The Internet Configuration Wizard MUST be run for QX IP PBX to be connected to
the Internet.
To Next Page
Loading...
Need help?
General
