Epygi QX50 User Manual

QX50/QX200/QX2000; (SW Version 6.0.x) 23
QX50/QX200/QX2000 Manual II: Administrator’s Guide
Extensions Management
The Extensions Management page is used to create a variety of extensions and auto attendants on the QX IP PBX. From this page, by clicking on the user
extension, the Administrator can go to the extension settings pages.
When this page is accessed for the first time after the QX IP
PBX’s initial boot-up or the default configuration settings
restore, an intermediate page is displayed.
The Change Extension Length page is used to define the
extension settings applicable to all extensions on the QX IP
PBX. This page disappears once being saved.
The Change Extension Length page consists of a radio-
button selection:
Fig.II- 23: Extensions Management - Add Entry page
• Leave Current Length radio-button selection is used to leave the current length of extensions on the QX IP PBX. Per default the extensions
length on the QX50/QX200 is 3 and on the QX2000 is 4. In front of this selection, the actual configured length of extensions is displayed.
• Change Length radio-button selection is used to change the actual length of extensions on the QX IP PBX. This selection enables the following
information to be defined:
The Extension Length drop-down list requires you to choose the length of the extensions on the QX IP PBX. This number will apply to all
existing extensions on the QX IP PBX as well as to any newly created extensions. The length of the extension can be 3, 4 or 5.
The Extension Prefix text field is used to define a prefix with which all existing extensions on the QX IP PBX as well as to any newly
created extensions should start. The prefix cannot start with the digits 0 or 9, otherwise an error message appears.
Please Note: By saving the settings on the Change Extension Length page, all existing extensions will lose the custom voice messages and voice mails in
the voice mailbox. The device will be rebooted. You will not be automatically redirected to the login page, so you need to access it manually again when
reboot ends. After the reboot, the Change Extension Length page will disappear and the Extensions Management page will be displayed. The Change
Extension Length page will not appear again unless the default configuration settings are restored on the device.
Two types of user extensions, active and inactive, can be created on the QX IP PBX. Active extensions are those that are attached to a line, can place and
receive calls and use available telephony services. Inactive extensions are those that are not attached to the line. They can use some available telephony
services but they cannot place and receive calls. Instead, inactive extensions have a voice mailbox available to store the messages from callers.
QX50/QX200 has two available FXS lines.
Attendant extensions are dedicated to the IVR system on the QX IP PBX. These extensions are used by callers to reach QX IP PBX’s users and use the
remote access and call relay services. It is possible to create Auto Attendants with the custom scenarios. By default, QX IP PBX has one Auto Attendant
extension (00) which is undeletable.
Attention: QX50 is limited to 200 extensions, QX200 is limited to 400 extensions and QX2000 is limited to 2400 extensions.
The Extensions table is a list of all extensions and their parameters.
Fig.II- 24: Extensions Management page

Epygi QX50 Specifications

General

Brand	Epygi
Model	QX50
Category	Network Hardware
Language	English