The Door/Window Sensor comprises of a transmitter and a magnet. The Sensor can be
mounted on doors, windows and any other object that can be opened or closed. When
the transmitter and magnet are separated by more than 2 cm, the Sensor will send a
signal to the Control Panel to trigger an alarm.
Overview
Door/Window Sensor
PCB Layout
11
Note: When the tamper switch is pressed the system will alarm immediately
Battery
Tamper
Switch
Zone
Setting
Transmitter
Magnet
Status Indicator
The supplied Door/Window Sensor is set to Normal Zone by default, the PIR Motion
Sensor is set to Home Mode zone. You can change their zone type by following the
steps on page 25.
Status Indicator
Test
1. Remove the battery compartment cover (push down and slide away)
2. Pull out the battery isolation strip. The Sensor will work immediately.
3. Press the button on the Remote Control to arm the system. Move the [Arm ]
magnet away from the transmitter, the LED will light up and the Control Panel will
alarm indicating that the Sensor is operating.
Note: The distance between the transmitter and the magnet must not exceed 1 cm when
in the closed position.
Blinks once: Door/window is opened
Blinks once per 3 seconds: Low battery - battery replacement required
To Next Page
Loading...
